EasyManua.ls Logo

Dräger Infinity Delta - Page 69

Dräger Infinity Delta
614 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SPECIALTY MENUS
VF8 DELTA/DELTA XL/KAPPA 2-19
The Menu Setup submenu
Menu Setup Determines amount of time menus and
screens remain displayed
NOTE: This setting determines menu
display time in Remote View also.
1) Click on Menu Setup.
2) Click on Menu Time Limit.
3) Click on one of the following:
ON – Active menus and screens
are displayed for a limited time
only (approximately 5 minutes).
OFF – Menus and screens
remain displayed until you
cancel them or select another
display.
The Save/Restore and Rename Setups submenus
These menus allow the unit manager to save and restore user-defined and default setups. Open
the Unit Manager menu (page 2-14), click on Save/Restore or Rename Setups, then follow the
procedures outlined on page 2-10 to execute the indicated functions.
The TPO
2
/CO
2
submenu
This menu configures the monitor for transcutaneous blood gas monitoring. Open the Unit
Manager menu (page 2-14), click on TPO2/CO2, select and execute functions as described in this
table. For more about tpO
2
/CO
2
functions, see page 18-10.
Site Timer
Control
Restricts or permits access to the site
timer (see page 18-11).
Nurse – Clinical personnel can
set the site timer in the
tpO
2
/CO
2
menu.
Manager – Access to the site
timer is restricted by the
password-protected Unit
Manager menu.
Site Timer Limits the use of the tpO
2
/CO
2
sensor to a
specified period of time. When the time
has expired, an alarm sounds and all
network devices are advised with a
message.
0.5 - 8.0 hr in 0.5 hr increments
•OFF
Timer OFF
Control
Enables/disables the control of the site
timer (see page 18-11).
ON – Only the unit manager can
disable the site timer.
OFF – The clinical personnel
can disable the site timer in the
tpO
2
/CO
2
menu.
Auto Heater
Shutdown
Refer to your hospital’s policy for this
feature.
NOTE:
The sensor heater is disabled in standby
mode to conserve power and prolong the
life of the sensor.
ON – Disables the sensor
heater when site timer expires.
OFF – Continues tpO
2
/CO
2
monitoring when the site timer
expires.
The Unit Manager Menu
Menu Item Description Available Settings

Table of Contents

Other manuals for Dräger Infinity Delta

Related product manuals