MAINTENANCE MENU
Eco Manual
201
Auto Power Down
When this is On, the backlight will power down ("go to sleep") if no activations are made for 2,
5 or 10 minutes, depending on choice you make. See pages
Error! Bookmark not defined. for
more information.
Hardware Diagnostics
These options allow you to test the display, the switches, the speech amplifier and various other
device configurations. If you have problems with your device and call the PRC Service
Department, you may be asked to check some things in this menu. Otherwise, you should leave
this option alone. The one option you may use occasionally is the Phone Configuration menu.
Read more about this option in the
Using the Cell Phone chapter of this manual.
System Information:
Check for versions of software, whether Data Logging is on or off and how much synthesized
memory you have left.
You may need to give the information in the System Information box to a service
representative if you call in because of a problem.
Erase All Vocabulary
If you select this, the system erases all its memory and resets itself to blank User Areas. You
must go to the
USER AREA MENU and re-load vocabulary into each Area.
Reset to Factory Defaults
This option effects the ECO software only. It has no effect on the integrated computer
applications or the device's hard drive.
If you want to return your ECO software to its original state, activate this option. All of your
User Areas will be re-set exactly the way they were when you received the device from PRC.
Perform a memory transfer before activating this option if you want any of your current
vocabulary to be saved.
Enable PCS Symbols ON/OFF
This option allows you to turn on and use PCS symbols. PCS symbols are an option that you
can purchase. You must have a password to activate this option in the menu. Call PRC for more
information.
Enable Integrated Device
You will use this option if you have a dedicated ECO and later purchased the use of the internal
computer. You will receive a password from the PRC Sales Department which you must enter
into your ECO before the integrated functions will become active. Select this option and enter
your password. Then exit the menu.
To Next Page
Loading...