Edge-Core ES4626F

Setting the System Clock
4-41
4
Recurring Mode – Sets the start, end, and offset times of summer-time for the switch
on a recurring basis. This mode sets the summer-time time zone relative to the
currently configured time zone. To specify a time corresponding to your local time
when summer-time is in effect, you must indicate the number of minutes your
summer-time time zone deviates from your regular time zone.
• Offset – Summer-time offset from the regular time zone, in minutes.
(Range: 0-99 minutes)
• From – Start time for summer-time offset.
• To – End time for summer-time offset.
Web – Select SNTP, Summer Time. Select one of the configuration modes,
configure the relevant attributes, enable summer time status, and click Apply.
Figure 4-27 Summer Time
CLI - This example configures summer time to take effect for a predefined zone.
Console(config)#clock summer-time MESZ predefined usa 23-41
Console#