Edge-Core ES4626F User Manual

Configuring the DHCP Server
17-7
17
Configuring a Network Address Pool
Web – Click DHCP, Server, Pool Configuration. Click the Configure button for any
entry. Click the radio button for “Network.” Enter the IP address and subnet mask for
the network pool. Configure the optional parameters such as gateway server and
DNS server. Then click Apply.
Figure 17-4 DHCP Server Pool - Network Configuration
CLI – This example configures a network address pool.
Console(config)#ip dhcp pool tps 39-6
Console(config-dhcp)#network 10.1.0.0 255.255.255.0 39-7
Console(config-dhcp)#default-router 10.1.0.253 39-8
Console(config-dhcp)#dns-server 10.2.3.4 39-9
Console(config-dhcp)#netbios-name-server 10.1.0.33 39-10
Console(config-dhcp)#netbios-node-type hybrid 39-11
Console(config-dhcp)#domain-name example.com 39-8
Console(config-dhcp)#bootfile wme.bat 39-10
Console(config-dhcp)#next-server 10.1.0.21 39-9
Console(config-dhcp)#lease infinite 39-11
Console(config-dhcp)#

Edge-Core ES4626F Specifications

General

Model	ES4626F
Ports	26
Gigabit Ports	24
Power Supply	AC 100-240V, 50-60Hz
Switching Capacity	128 Gbps
Forwarding Rate	95.2 Mpps
MAC Address Table Size	16K
Redundant Power Supplies	Optional
Storage Humidity	5% to 95% (non-condensing)
Layer	L3
Dimensions	440 x 44 x mm
Management	CLI, Web, SNMP
Jumbo Frame Support	9K
Dimensions (W x D x H)	440 x 44 mm
Operating Temperature	0°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% (non-condensing)