Edge-Core ES4626F

User Authentication Commands
25-26
25
Example
The following example enables port security for port 5, and sets the response to a
security violation to issue a trap message:
Related Commands
shutdown (27-7)
mac-address-table static (31-1)
802.1X Port Authentication
The switch supports IEEE 802.1X (dot1x) port-based access control that prevents
unauthorized access to the network by requiring users to first submit credentials for
authentication. Client authentication is controlled centrally by a RADIUS server
using EAP (Extensible Authentication Protocol).
Console(config)#interface ethernet 1/5
Console(config-if)#port security action trap
Table 25-13 802.1X Port Authentication Commands
Command Function Mode Page
dot1x system-auth-control Enables dot1x globally on the switch. GC 25-27
dot1x default Resets all dot1x parameters to their default values GC 25-27
dot1x max-req Sets the maximum number of times that the switch
retransmits an EAP request/identity packet to the client
before it times out the authentication session
IC 25-27
dot1x port-control Sets dot1x mode for a port interface IC 25-28
dot1x operation-mode Allows single or multiple hosts on an dot1x port IC 25-29
dot1x re-authenticate Forces re-authentication on specific ports PE 25-30
dot1x re-authentication Enables re-authentication for all ports IC 25-30
dot1x timeout quiet-period Sets the time that a switch port waits after the Max
Request Count has been exceeded before attempting to
acquire a new client
IC 25-31
dot1x timeout re-authperiod Sets the time period after which a connected client must
be re-authenticated
IC 25-31
dot1x timeout tx-period Sets the time period during an authentication session that
the switch waits before re-transmitting an EAP packet
IC 25-32
show dot1x Shows all dot1x related information PE 25-32