Edge-Core ES4626F

Global Routing Configuration
42-3
42
clear ip route
This command removes dynamically learned entries from the IP routing table.
Syntax
clear ip route {network [netmask] | *}
• network – Network or subnet address.
• netmask - Network mask for the associated IP subnet. This mask identifies
the host address bits used for routing to specific subnets.
• * – Removes all dynamic routing table entries.
Command Mode
Privileged Exec
Command Usage
• This command only clears dynamically learned routes.
•Use the no ip address command to remove a local interface.
•Use the no ip route command to remove a static route.
Example
show ip route
This command displays information in the IP routing table.
Syntax
show ip route [config | address [netmask]]
• config – Displays all static routing entries.
• address – IP address of the destination network, subnetwork or host for
which routing information is to be displayed.
• netmask - Network mask for the associated IP subnet. This mask identifies
the host address bits used for routing to specific subnets.
Command Mode
Privileged Exec
Command Usage
If the address is specified without the netmask parameter, the router displays
all routes for the corresponding natural class address (page 42-9).
Console#clear ip route 10.1.5.0
Console#