System Management Commands
23-36
23
sntp client
This command enables SNTP client requests for time synchronization from NTP or
SNTP time servers specified with the sntp servers command. Use the no form to
disable SNTP client requests.
Syntax
[no] sntp client
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
• The time acquired from time servers is used to record accurate dates and
times for log events. Without SNTP, the switch only records the time starting
from the factory default set at the last bootup (i.e., 00:00:00, Jan. 1, 2001).
• This command enables client time requests to time servers specified via the
sntp servers command. It issues time synchronization requests based on the
interval set via the sntp poll command.
Example
clock summertime (date) Configures summer time (daylight savings time) for the
switch’s internal clock
GC 23-40
clock summertime
(predefined)
Configures summer time (daylight savings time) for the
switch’s internal clock
GC 23-41
clock summertime (recurring) Configures summer time (daylight savings time) for the
switch’s internal clock
GC 23-42
show clock Shows the time zone and summer-time settings PE 23-43
calendar set Sets the system date and time PE 23-44
show calendar Displays the current date and time setting NE, PE 23-44
Console(config)#sntp server 10.1.0.19
Console(config)#sntp poll 60
Console(config)#sntp client
Console(config)#end
Console#show sntp
Current time: Dec 23 02:52:44 2002
Poll interval: 60
Current mode: unicast
SNTP status : Enabled
SNTP server 137.92.140.80 0.0.0.0 0.0.0.0
Current server: 137.92.140.80
Console#
Table 23-13 Time Commands (Continued)
Command Function Mode Page
To Next Page
Loading...
Need help?
General