Line Commands
23-17
23
Line Commands
You can access the onboard configuration program by attaching a VT100
compatible device to the server’s serial port. These commands are used to set
communication parameters for the serial port or Telnet (i.e., a virtual terminal).
line
This command identifies a specific line for configuration, and to process subsequent
line configuration commands.
Syntax
line {console | vty}
• console - Console terminal line.
• vty - Virtual terminal for remote console access (i.e., Telnet).
Default Setting
There is no default line.
Command Mode
Global Configuration
Table 23-7 Line Commands
Command Function Mode Page
line Identifies a specific line for configuration and starts the line
configuration mode
GC 23-17
login Enables password checking at login LC 23-18
password Specifies a password on a line LC 23-19
timeout login
response
Sets the interval that the system waits for a login attempt LC 23-20
exec-timeout Sets the interval that the command interpreter waits until user
input is detected
LC 23-20
password-thresh Sets the password intrusion threshold, which limits the number of
failed logon attempts
LC 23-21
silent-time
*
* These commands only apply to the serial port.
Sets the amount of time the management console is inaccessible
after the number of unsuccessful logon attempts exceeds the
threshold set by the password-thresh command
LC 23-22
databits
*
Sets the number of data bits per character that are interpreted and
generated by hardware
LC 23-22
parity
*
Defines the generation of a parity bit LC 23-23
speed
*
Sets the terminal baud rate LC 23-23
stopbits
*
Sets the number of the stop bits transmitted per byte LC 23-24
disconnect Terminates a line connection PE 23-24
show line Displays a terminal line's parameters NE, PE 23-25
To Next Page
Loading...
Need help?
General