System Management Commands
23-34
23
Default Setting
None
Command Mode
Global Configuration
Command Usage
You may use an symbolic email address that identifies the switch, or the
address of an administrator responsible for the switch.
Example
logging sendmail destination-email
This command specifies the email recipients of alert messages. Use the no form to
remove a recipient.
Syntax
[no] logging sendmail destination-email email-address
email-address - The source email address used in alert messages.
(Range: 1-41 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
You can specify up to five recipients for alert messages. However, you must
enter a separate command to specify each recipient.
Example
logging sendmail
This command enables SMTP event handling. Use the no form to disable this
function.
Syntax
[no] logging sendmail
Default Setting
Enabled
Console(config)#logging sendmail source-email bill@this-company.com
Console(config)#
Console(config)#logging sendmail destination-email ted@this-company.com
Console(config)#
To Next Page
Loading...
Need help?
General