Edge-Core ES4626F

Routing Information Protocol (RIP)
42-5
42
show ip traffic
This command displays statistics for IP, ICMP, UDP, TCP and ARP protocols.
Command Mode
Privileged Exec
Command Usage
For a description of the information shown by this command, see “Displaying
Statistics for IP Protocols” on page 19-16.
Example
Routing Information Protocol (RIP)
This section describes commands used to configure RIP global and interface
parameters for dynamic routing on the switch.
Console#show ip traffic
IP statistics:
Rcvd: 5 total, 5 local destination
0 checksum errors
0 unknown protocol, 0 not a gateway
Frags: 0 reassembled, 0 timeouts
0 fragmented, 0 couldn't fragment
Sent: 9 generated
0 no route
ICMP statistics:
Rcvd: 0 checksum errors, 0 redirects, 0 unreachable, 0 echo
5 echo reply, 0 mask requests, 0 mask replies, 0 quench
0 parameter, 0 timestamp
Sent: 0 redirects, 0 unreachable, 0 echo, 0 echo reply
0 mask requests, 0 mask replies, 0 quench, 0 timestamp
0 time exceeded, 0 parameter problem
UDP statistics:
Rcvd: 0 total, 0 checksum errors, 0 no port
Sent: 0 total
TCP statistics:
Rcvd: 0 total, 0 checksum errors
Sent: 0 total
ARP statistics:
Rcvd: 0 requests, 1 replies
Sent: 1 requests, 0 replies
Console#
Table 42-5 Routing Information Protocol Commands
Command Function Mode Page
router rip Enables the RIP routing protocol GC 42-6
default-metric Sets the default metric assigned to external routes imported from
other protocols
RC 42-7
timers basic Sets basic timers, including update, timeout, garbage collection RC 42-8
network Specifies the network interfaces that are to use RIP routing RC 42-9
neighbor Defines a neighboring router with which to exchange information RC 42-9