Time Commands
23-37
23
Related Commands
sntp server (23-37)
sntp poll (23-37)
show sntp (23-38)
sntp server
This command sets the IP address of the servers to which SNTP time requests are
issued. Use the this command with no arguments to clear all time servers from the
current list.
Syntax
sntp server [ip1 [ip2 [ip3]]]
ip - IP address of an time server (NTP or SNTP).
(Range: 1 - 3 addresses)
Default Setting
None
Command Mode
Global Configuration
Command Usage
This command specifies time servers from which the switch will poll for time
updates when set to SNTP client mode. The client will poll the time servers in
the order specified until a response is received. It issues time synchronization
requests based on the interval set via the sntp poll command.
Example
Related Commands
sntp client (23-36)
sntp poll (23-37)
show sntp (23-38)
sntp poll
This command sets the interval between sending time requests when the switch is
set to SNTP client mode. Use the no form to restore to the default.
Syntax
sntp poll seconds
no sntp poll
seconds - Interval between time requests. (Range: 16-16384 seconds)
Console(config)#sntp server 10.1.0.19
Console#
To Next Page
Loading...
Need help?
General