LLDP Commands
32-10
32
Command Usage
The system name is taken from the sysName object in RFC 3418, which
contains the system’s administratively assigned name, and is in turn based on
the hostname command (page 23-1).
Example
lldp dot1-tlv proto-ident
This command configures an LLDP-enabled port to advertise the supported
protocols. Use the no form to disable this feature.
Syntax
[no] lldp
dot1-tlv proto-ident
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option advertises the protocols that are accessible through this interface.
Example
lldp dot1-tlv proto-vid
This command configures an LLDP-enabled port to advertise port related VLAN
information. Use the no form to disable this feature.
Syntax
[no] lldp dot1-tlv proto-vid
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Console(config)#interface ethernet 1/1
Console(config-if)#lldp basic-tlv system-name
Console(config-if)#
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot1-tlv proto-ident
Console(config-if)#
To Next Page
Loading...
Need help?
General