System Status Commands
23-5
23
show running-config
This command displays the configuration information currently in use.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
• Use this command in conjunction with the show startup-config command to
compare the information in running memory to the information stored in
non-volatile memory.
• This command displays settings for key command modes. Each mode group
is separated by “!” symbols, and includes the configuration mode command,
and corresponding commands. This command displays the following
information:
- MAC address for each switch in the stack
- SNTP server settings
- SNMP community strings
- Users (names, access levels, and encrypted passwords)
- VLAN database (VLAN ID, name and state)
- VLAN configuration settings for each interface
- Multiple spanning tree instances (name and interfaces)
- IP address configured for VLANs
- Layer 4 precedence settings
- Routing protocol configuration settings
- Spanning tree settings
- Any configured settings for the console port and Telnet
To Next Page
Loading...
Need help?
General