Edge-Core ES4626F User Manual

Class of Service
13-12
13
Click Priority, IP Port Priority. Enter the port number for a network application in the
IP Port Number box and the new CoS value in the Class of Service box, and then
click Apply.
Figure 13-9 IP Port Priority
CLI – The following example globally enables IP Port Priority service on the switch,
maps HTTP traffic (on port 1) to CoS value 0, and then displays the IP Port Priority
settings.
* Mapping specific values for IP Port Priority is implemented as an interface configuration
command, but any changes will apply to the all interfaces on the switch.
Console(config)#map ip port
35-7
Console(config)#interface ethernet 1/1 27-1
Console(config-if)#map ip port 80 cos 0
35-8
Console(config-if)#end
Console#show map ip port ethernet 1/5
35-11
TCP port mapping status: disabled
Port Port no. COS
--------- -------- ---
Eth 1/ 1 80 0
Console#

Edge-Core ES4626F Specifications

General

Model	ES4626F
Ports	26
Gigabit Ports	24
Power Supply	AC 100-240V, 50-60Hz
Switching Capacity	128 Gbps
Forwarding Rate	95.2 Mpps
MAC Address Table Size	16K
Redundant Power Supplies	Optional
Storage Humidity	5% to 95% (non-condensing)
Layer	L3
Dimensions	440 x 44 x mm
Management	CLI, Web, SNMP
Jumbo Frame Support	9K
Dimensions (W x D x H)	440 x 44 mm
Operating Temperature	0°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% (non-condensing)