Edge-Core ES4626F

MAC ACLs
26-15
26
show mac access-list
This command displays the rules for configured MAC ACLs.
Syntax
show mac access-list [acl_name]
acl_name – Name of the ACL. (Maximum length: 16 characters)
Command Mode
Privileged Exec
Example
Related Commands
permit, deny 26-13
mac access-group (26-15)
mac access-group
This command binds a port to a MAC ACL. Use the no form to remove the port.
Syntax
mac access-group acl_name in
• acl_name – Name of the ACL. (Maximum length: 16 characters)
• in – Indicates that this list applies to ingress packets.
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Command Usage
• A port can only be bound to one ACL.
• If a port is already bound to an ACL and you bind it to a different ACL, the
switch will replace the old binding with the new one.
Example
Related Commands
show mac access-list (26-15)
Console#show mac access-list
MAC access-list jerry:
permit any 00-e0-29-94-34-de ethertype 0800
Console#
Console(config)#interface ethernet 1/2
Console(config-if)#mac access-group jerry in
Console(config-if)#