Edge-Core ES4626F

IP Routing Commands
42-6
42
router rip
This command enables Routing Information Protocol (RIP) routing for all IP
interfaces on the router. Use the no form to disable it.
Syntax
[no] router rip
Command Mode
Global Configuration
Default Setting
Disabled
Command Usage
• RIP is used to specify how routers exchange routing table information.
• This command is also used to enter router configuration mode.
Example
Related Commands
network (42-9)
version Specifies the RIP version to use on all network interfaces (if not
already specified with a receive version or send version
command)
RC 42-11
redistribute Redistribute routes from one routing domain to
another
RC 42-11
ip rip receive version Sets the RIP receive version to use on a network interface IC 42-12
ip rip send version Sets the RIP send version to use on a network interface IC 42-13
ip split-horizon Enables split-horizon or poison-reverse loop prevention IC 42-14
ip rip authentication key Enables authentication for RIP2 packets and specifies keys IC 42-14
ip rip authentication
mode
Specifies the type of authentication used for RIP2 packets IC 42-15
show rip globals Displays global configuration settings and statistics for RIP PE 42-16
show ip rip Displays RIP configuration information for each network interface PE 42-16
Console(config)#router rip
Console(config-router)#
Table 42-5 Routing Information Protocol Commands (Continued)
Command Function Mode Page