DHCP Commands
39-10
39
bootfile
This command specifies the name of the default boot image for a DHCP client. This
file should placed on the Trivial File Transfer Protocol (TFTP) server specified with
the next-server command. Use the no form to delete the boot image name.
Syntax
bootfile filename
no bootfile
filename - Name of the file that is used as a default boot image.
Default Setting
None
Command Mode
DHCP Pool Configuration
Example
Related Commands
next-server (39-9)
netbios-name-server
This command configures NetBIOS Windows Internet Naming Service (WINS)
name servers that are available to Microsoft DHCP clients. Use the no form to
remove the NetBIOS name server list.
Syntax
netbios-name-server address1 [address2]
no netbios-name-server
• address1 - Specifies IP address of primary NetBIOS WINS name server.
• address2 - Specifies IP address of alternate NetBIOS WINS name server.
Default Setting
None
Command Mode
DHCP Pool Configuration
Usage Guidelines
Servers are listed in order of preference (starting with address1 as the most
preferred server).
Example
Console(config-dhcp)#bootfile wme.bat
Console(config-dhcp)#
Console(config-dhcp)#netbios-name-server 10.1.0.33 10.1.0.34
Console(config-dhcp)#
To Next Page
Loading...
Need help?
General