Simple Network Management Protocol
5-2
5
Note: The predefined default groups and view can be deleted from the system. You can
then define customized groups and views for the SNMP clients that require access.
Enabling the SNMP Agent
Enables SNMPv3 service for all management clients (i.e., versions 1, 2c, 3).
Command Attributes
SNMP Agent Status – Enables SNMP on the switch.
Web – Click SNMP, Agent Status. Enable the SNMP Agent by marking the Enabled
checkbox, and click Apply.
Figure 5-1 Enabling the SNMP Agent
CLI – The following example enables SNMP on the switch.
Table 5-1 SNMPv3 Security Models and Levels
Model Level Group Read View Write View Notify View Security
v1 noAuthNoPriv public
(read only)
defaultview none none Community string only
v1 noAuthNoPriv private
(read/write)
defaultview defaultview none Community string only
v1 noAuthNoPriv user defined user defined user defined user defined Community string only
v2c noAuthNoPriv public
(read only)
defaultview none none Community string only
v2c noAuthNoPriv private
(read/write)
defaultview defaultview none Community string only
v2c noAuthNoPriv user defined user defined user defined user defined Community string only
v3 noAuthNoPriv user defined user defined user defined user defined A user name match only
v3 AuthNoPriv user defined user defined user defined user defined Provides user
authentication via MD5 or
SHA algorithms
v3 AuthPriv user defined user defined user defined user defined Provides user
authentication via MD5 or
SHA algorithms and data
privacy using DES 56-bit
encryption
Console(config)#snmp-server 24-2
Console(config)#
To Next Page
Loading...
Need help?
General