DHCP Server
39-11
39
Related Commands
netbios-node-type (39-11)
netbios-node-type
This command configures the NetBIOS node type for Microsoft DHCP clients. Use
the no form to remove the NetBIOS node type.
Syntax
netbios-node-type type
no netbios-node-type
type - Specifies the NetBIOS node type:
• broadcast
• hybrid (recommended)
• mixed
• peer-to-peer
Default Setting
None
Command Mode
DHCP Pool Configuration
Example
Related Commands
netbios-name-server (39-10)
lease
This command configures the duration that an IP address is assigned to a DHCP
client. Use the no form to restore the default value.
Syntax
lease {days [hours][minutes] | infinite}
no lease
• days - Specifies the duration of the lease in numbers of days.
(Range: 0-364)
• hours - Specifies the number of hours in the lease. A days value must be
supplied before you can configure hours. (Range: 0-23)
• minutes - Specifies the number of minutes in the lease. A days and hours
value must be supplied before you can configure minutes. (Range: 0-59)
• infinite - Specifies that the lease time is unlimited. This option is normally
used for addresses manually bound to a BOOTP client via the host
command.
Console(config-dhcp)#netbios-node-type hybrid
Console(config-dhcp)#
To Next Page
Loading...
Need help?
General