Edge-Core ES4626F

DHCP Server
39-5
39
DHCP Server
service dhcp
This command enables the DHCP server on this switch. Use the no form to disable
the DHCP server.
Syntax
[no] service dhcp
Default Setting
Enabled
Command Mode
Global Configuration
Table 39-4 DHCP Server Commands
Command Function Mode Page
service dhcp Enables the DHCP server feature on this switch GC 39-5
ip dhcp
excluded-address
Specifies IP addresses that a DHCP server should not assign to
DHCP clients
GC 39-6
ip dhcp pool Configures a DHCP address pool on a DHCP Server GC 39-6
network Configures the subnet number and mask for a DHCP address
pool
DC 39-7
default-router Specifies the default router list for a DHCP client DC 39-8
domain-name Specifies the domain name for a DHCP client DC 39-8
dns-server Specifies the Domain Name Server (DNS) servers available to a
DHCP client
DC 39-9
next-server Configures the next server in the boot process of a DHCP client DC 39-9
bootfile Specifies a default boot image for a DHCP client DC 39-10
netbios-name-server Configures NetBIOS Windows Internet Naming Service (WINS)
name servers available to Microsoft DHCP clients
DC 39-10
netbios-node-type Configures NetBIOS node type for Microsoft DHCP clients DC 39-11
lease Sets the duration an IP address is assigned to a DHCP client DC 39-11
host
*
* These commands are used for manually binding an address to a client.
Specifies the IP address and network mask to manually bind to a
DHCP client
DC 39-12
client-identifier
*
Specifies a client identifier for a DHCP client DC 39-13
hardware-address
*
Specifies the hardware address of a DHCP client DC 39-14
clear ip dhcp binding Deletes an automatic address binding from the DHCP server
database
PE 39-14
show ip dhcp binding Displays address bindings on the DHCP server PE,
NE
39-15