Configuring Rate Limits
8-21
8
Web - Click Port, Rate Limit, Input/Output Port/Trunk Configuration. Set the Input
Rate Limit Status or Output Rate Limit Status, then set the rate limit for the individual
interfaces, and click Apply.
Figure 8-11 Rate Limit Configuration
CLI - This example sets the rate limit for input and output traffic passing through
port 1 to 600 Mbps.
Console(config)#interface ethernet 1/1 27-1
Console(config-if)#rate-limit input 600 30-1
Console(config-if)#rate-limit output 600
Console(config-if)#
To Next Page
Loading...
Need help?
General