LLDP Commands
32-8
32
• Every management address TLV that reports an address that is accessible on
a port and protocol VLAN through the particular port should be accompanied
by a port and protocol VLAN TLV that indicates the VLAN identifier (VID)
associated with the management address reported by this TLV.
Example
lldp basic-tlv port-description
This command configures an LLDP-enabled port to advertise its port description.
Use the no form to disable this feature.
Syntax
[no] lldp basic-tlv port-description
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
The port description is taken from the ifDescr object in RFC 2863, which
includes information about the manufacturer, the product name, and the
version of the interface hardware/software.
Example
lldp basic-tlv system-capabilities
This command configures an LLDP-enabled port to advertise its system capabilities.
Use the no form to disable this feature.
Syntax
[no] lldp basic-tlv system-capabilities
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Console(config)#interface ethernet 1/1
Console(config-if)#lldp basic-tlv management-ip-address
Console(config-if)#
Console(config)#interface ethernet 1/1
Console(config-if)#lldp basic-tlv port-description
Console(config-if)#
To Next Page
Loading...
Need help?
General