Edge-Core ES4626F

System Management Commands
23-2
23
Command Mode
Global Configuration
Example
switch renumber
This command resets the switch unit identification numbers in the stack. All stack
members are numbered sequentially starting from the top unit for a non-loop stack,
or starting from the Master unit for a looped stack.
Syntax
switch all renumber
Default Setting
• For non-loop stacking, the top unit is unit 1.
• For loop stacking, the master unit is unit 1.
Command Mode
Global Configuration
Example
This example shows how to renumber all units.
Console(config)#hostname RD#1
Console(config)#
Console#switch all renumber
Console#