Edge-Core ES4626F

Contents
iv
Main Menu 3-4
Chapter 4: Basic Management Tasks 4-1
Displaying System Information 4-1
Displaying Switch Hardware/Software Versions 4-3
Displaying Bridge Extension Capabilities 4-4
Setting the Switch’s IP Address (IP Version 4) 4-5
Manual Configuration 4-7
Using DHCP/BOOTP 4-8
Setting the Switch’s IP Address (IP Version 6) 4-9
Configuring an IPv6 Address 4-9
Configuring an IPv6 General Network Prefix 4-15
Configuring Neighbor Detection Protocol and Static Entries 4-17
Configuring Support for Jumbo Frames 4-21
Managing Firmware 4-21
Downloading System Software from a Server 4-22
Saving or Restoring Configuration Settings 4-24
Downloading Configuration Settings from a Server 4-25
Console Port Settings 4-26
Telnet Settings 4-28
Configuring Event Logging 4-30
System Log Configuration 4-30
Remote Log Configuration 4-31
Displaying Log Messages 4-33
Sending Simple Mail Transfer Protocol Alerts 4-33
Renumbering the Stack 4-35
Resetting the System 4-36
Setting the System Clock 4-36
Setting the Current Time 4-37
Configuring SNTP 4-37
Setting the Time Zone 4-39
Configuring Summer Time 4-40
Chapter 5: Simple Network Management Protocol 5-1
Enabling the SNMP Agent 5-2
Setting Community Access Strings 5-3
Specifying Trap Managers and Trap Types 5-4
Configuring SNMPv3 Management Access 5-7
Setting a Local Engine ID 5-7
Specifying a Remote Engine ID 5-8
Configuring SNMPv3 Users 5-9
Configuring Remote SNMPv3 Users 5-11
Configuring SNMPv3 Groups 5-13
Setting SNMPv3 Views 5-17