To sort the jobs, press ALT > F1 Sort by Alphabet or ALT > F3 Reverse Sort Order.
4.
Press F4 Select Job.
The Current Job screen displays the job.
6.2.5 Change the job ID for an Analyze job
1. From the Analyze main menu, press F9 Job Setup.
2. To switch between internal memory or a memory card, press F1 Change Job > F3
Change Location.
3. Select a job and press F4 Select Job.
4. Press F3 Edit This Job > F2 Edit Job ID.
5. Enter up to 10 characters. You cannot use the following characters: \ . : / * # ? " | < >
6. Press Enter.
6.2.6 Edit the equipment ID and description for an Analyze job
1. From the Analyze main menu, press F9 Job Setup.
2. To switch between internal memory or a memory card, press F1 Change Job > F3
Change Location.
3. Select a job and press F4 Select Job.
4. Press F3 Edit This Job.
5. Set the following options, as necessary.
Option Description
F7 Edit Equip ID Enter up to 10 characters to identify the equipment.
F8 Edit Equip Desc Enter up to 28 characters to describe the equipment.
6. Press Enter.
6.2.7 Edit the measurement ID and description for an Analyze
job
1. From the Analyze main menu, press F9 Job Setup.
2.
To switch between internal memory or a memory card, press F1 Change Job > F3
Change Location.
3. Select a job and press F4 Select Job.
4. Press F3 Edit This Job.
5. Select a measurement in the job.
6. Press F5 Edit Meas, and set the following options as necessary.
Analyze and Advanced Analyze
110 MHM-97432 Rev 7
To Next Page
Loading...
Need help?
General
