Job ManagerFigure 7-15:
Option Description
F1 Create New Job Create a new alignment job.
F2 Change Location Change the memory location where jobs are stored.
This key is active only if an external memory card is installed on the
analyzer.
F3 Edit This Job Edit parameters of the currently highlighted job.
F4 Select/Unselect Select or unselect a highlighted job.
Pressing this key places/removes a checkmark on the left of the selected
job.
F5 Select/Unselect All Select or unselect all jobs in the list.
Pressing this key places/removes checkmarks on the left side of all the
jobs on the list.
Advanced Laser Alignment
MHM-97432 Rev 7 183
To Next Page
Loading...
