Option Description
F6 Trim Run Acquire trim runs to ensure the machine is within the balance
specification based on your site or the machine manufacturer.
F7 Exit Balance Close Balance and return to the Home screen.
F8 Intentionally blank.
F9 Intentionally blank.
F10 Intentionally blank.
F11 Intentionally blank.
F12 Job Manager Create, copy, delete, activate or transfer a balance job.
ALT2 keys
Option Description
F1 Intentionally blank.
F2 Intentionally blank.
F3 Notes Create, add, or remove notes from a balance job or the analyzer.
Notes are saved with the job to help you remember important
information about a machine.
F4 Intentionally blank.
F5 Intentionally blank.
F6 Calculator Mode Calculate solutions for special circumstances, including
estimating the trial weight amount and location.
F7 Exit Balance Close Balance and return to the Home screen.
F8 Intentionally blank.
F9 Review/Edit Data Review or manually edit/enter balance job data. This is helpful if
you could not collect a reading, or you need to see the solution
for a hypothetical situation.
F10 Watch Dog Checks Review warning messages that occurred during the reference
run. This is available only after measurement runs are completed
for a job.
F11 Print Job Print a summary report of the balance job to AMS Machinery
Manager or a memory card inserted into the analyzer.
F12 Clear Job Data Clear all measurement data and notes, or all trim run data from
the active balance job.
Note
Use caution with the Clear Job Data option. Deleted data cannot
be recovered.
Balance
300 MHM-97432 Rev 7
To Next Page
Loading...
Need help?
General
