conserve battery power. The standby timer also shuts off the keypad backlight. The
standby timer is disabled when the power supply is connected to and powers the analyzer.
The blue LED displays on the front of the analyzer when the analyzer is in standby. To leave
standby, quickly press the power key.
Note
After 60 minutes in standby, the analyzer shuts down. You do not lose any data when this occurs.
Procedure
1.
Press Home > ALT > F2 General Setup > F4 Set Standby Time.
2. Enter the number of minutes between 1 and 30.
The default is 10 minutes.
3. Press Enter.
2.14.3 Set the backlight timer
To conserve battery pack power, set the timer to automatically turn off the backlight after
a specified period of inactivity, such as no data collection or key presses. After the timer
expires and the backlight is turned off, press a key or the screen to turn on the LCD
backlight and reset the timer. The timer is disabled when the power supply is connected to
and powers the analyzer.
In this power save mode, the LCD backlight is off and the blue LED blinks on the front of the
analyzer.
Procedure
1. Press Home > ALT > F2 General Setup > F5 Set Backlight Time.
2. Enter the number of seconds between 0 and 120.
A 0 disables this feature. The default is 30 seconds.
3. Press Enter.
2.14.4 Enable or disable printing to AMS Machinery Manager or
a memory card
You can enable or disable printing on the analyzer. When printing is enabled, you can send
routes, jobs, and summary reports to AMS Machinery Manager or an inserted SD (Secure
Digital) memory card. By default, the analyzer can send files to AMS Machinery Manager.
Procedure
1.
Press Home > ALT > F2 General Setup > F6 Set Print Mode.
2. Use the up and down arrow keys to select an option.
Introduction to the analyzer
MHM-97432 Rev 7 29
To Next Page
Loading...
Need help?
General
