Epson Stylus Pro 4450 - Page 328

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Disassembly & Assembly Disassembly Procedures 328
4.2.8.10 Holder, FFC; B
1. Move the "Carriadge Unit" depending on which "Holder, FFC; B" is
removed with reference to both Figure 4-170 and the table below.
2. Pinch the upper and lower end of the two "Harness, Head"s and the
"Harness, Head, Intermit" with your fingers to make their central parts
bowed, and release them from the upper and lower tabs of the "Holder,
FFC; B".
Figure 4-170. Holder, FFC; B
Figure 4-171. Holder, FFC; B Removal
"Holder, FFC; B" to be removed "Carriage Unit" position
A ~ B Home position
C ~ E Left end
C A U T I O N
Bend the "Harness, Head"s and "Harness, Head, Intermit"
slowly and carefully so as not to fold them down.
E D
C
B
A
Tabs
Holder, FFC; B