Epson WorkForce AL-MX200DNF

Interval Timer
Purpose:
To specify an interval between transmission attempts within the range of 3 to 255 seconds. The default
is 8 seconds.
Number of Redial
Purpose:
To specify the number of redial attempts to make when the destination fax number is busy, within the
range of 0 to 9. If you specify 0, the printer will not redial. The default is 3.
Redial Delay
Purpose:
To specify an interval between redial attempts within the range of 1 to 15 minutes. The default is 1
minute.
Junk Fax Filter
Purpose:
To reject faxes from the numbers that are not included in the Address Book.
Values:
Off
*
Accepts all faxes.
On
Rejects faxes sent from the numbers that are not included in the Address Book.
*
Factory default menu setting
Note:
Ensure to register the fax numbers you want to accept faxes from in the Address Book before using Junk
Fax Filter.
Remote Receive
Purpose:
To receive a fax by pressing the remote receive code on the external telephone after picking up the
handset of the telephone.
Values:
AL-MX200 Series User’s Guide
Using the Operator Panel Menus and Keypad 285