Sleep Timer
6min
*
By default, the printer enters Sleep mode in six
minutes of inactivity starting from the moment it
entered Low Power mode. You can change the Sleep
Timer setting within a range from 6 to 11 minutes.
6min - 11min
*
Factory default menu setting
Select 1min (default) for Low Power Timer if your printer shares an electrical circuit with your room
lights and you notice them flickering. Otherwise, select a high value to keep your printer available for
frequent use with the minimum warm-up time.
The printer automatically exits a power saver mode when it receives a print job from a computer or fax
data through the telephone line. Alternatively, you can manually bring it back to the ready-to-print
state. Press any button on the operator panel in Low Power mode. In Sleep mode, press the
(Energy
Saver) button. Whether the printer is in Low Power or Sleep mode, it will take about 25 seconds for
the printer to resume the ready-to-print state.
Auto Reset
Purpose:
To specify a time period before the printer restores the default setting for the current menu item and
resumes the ready-to-print state when an attempt to change the setting is left unfinished.
Values:
45sec
*
1min
2min
3min
4min
*
Factory default menu setting
Fault Time-Out
Purpose:
To specify a time period before the printer cancels a job that has halted abnormally. Any job will be
cancelled when it times out.
Values:
AL-MX200 Series User’s Guide
Using the Operator Panel Menus and Keypad 293
To Next Page
Loading...
