120 Eos Family Operations Manual
[CopyTo] - copies a channel to another location within patch.
[CopyTo] {Plus Show} - copies a channel to another location within patch and all record tar-
gets in the show.
[CopyTo] {Only Show} - copies a channel to another location with all record targets in the
show but not the patch data.
[CopyTo] {Only Text} - copies only the notes and keyword fields from one channel to another.
Swapping Channels
Channels can be swapped for each other in patch:
[1] {Swap} [2] [Enter]
This syntax will replace channel 1's data with channel 2's and vice versa in patch and throughout the
entire show.
Note: Swap always impacts the entire show.
The following options are available with {Swap}:
{Swap} - swaps only the patched address
{Swap} {Plus Show} - swaps all show and patch data
{Swap} {Only Show} - swaps only the show data and not patch data
{Swap} {Plus Patch} - swaps addresses and patch data but not show data
Unpatch a Channel
To unpatch a channel while in patch you can press:
[n] {Unpatch} [Enter]
The {Unpatch} softkey will reset all the properties of the channel to the default. This includes remov-
ing the device type if specified.
To retain all the elements of a channel except its address, you would instead use:
[n] [At] [0] [Enter]
Using [At] [0] will allow unpatched channels to still be manipulated and have data stored for them,
but they do not output any information (as they are unpatched).
Deleting Channels
It is possible to delete channels in patch. Deleting channels is different from unpatching in that
deleted channels cannot be manipulated or have data stored for them. When deleted, the channel
numbers will still be visible in the live/blind display, but the channel graphic will be removed from the
display.
For Example:
To delete channels in the patch display, press:
To Next Page
Loading...
Need help?
General
