242 Eos Family Operations Manual
[Update] {Preset 1}
When updating a preset, only channels that are already in the preset will be updated. You need to
select channels or parameters to force new data into a preset when using [Update].
Using the Preset List
The preset list displays all recorded presets. The Preset List only allows you to change attributes; no
editing can be done directly in list view.
Opening the Preset List
Press [Preset] twice to open the list view. You can also open the list view from the home screen or by
using [Tab] + [2][6]. See Home Screen (on page50) for more information.
Pressing the {Edit} softkey takes you to the blind view of the selected preset, in the last format you
used in blind. This will allow you to edit the preset. You can change the blind display to spreadsheet
or table view by pressing the [Format] key.
You can navigate the preset list using [Next] and [Last].
Indicators for absolute (A), locked (L), and by type (T+) display to the right of the preset number.
Note: In the by type channels column, any channel number with an asterisk indicates that
the channel does not have any by type data stored to it.
Copy To
You can copy presets within the list to another location in the list using [CopyTo].
<Preset> [2] [CopyTo] [9] [Enter] [Enter] - copies the contents of preset 2 to preset 9. Preset 2
will remain in the list. The second [Enter] is not required if you have disabled confirmations in
setup.
You can also use [Copy To] from palettes to presets.
Move To
You can move presets within the preset list using the {Move To} softkey. You can also hit [Copy To]
[CopyTo] to access {Move To}.
<Preset> [3] {Move To} [8] [Enter] [Enter] - moves preset 3 to preset 8. Preset 3 will be removed
from the list. The second [Enter] is not required if you have disabled confirmations in setup.
To Next Page
Loading...
Need help?
General
