To Next Page

To Previous Page

374 Eos Family Operations Manual

[Sub] [2] MoveTo [Sub 9] [Enter][Enter] - moves the contents, label, and timing data

from submaster 2 and places it in submaster 9. Submaster 2 is removed.

You can copy the contents of a submaster by using the [CopyTo] button.

[Sub] [2] [Copy To] [Sub 9] [Enter][Enter] - copies the contents, label, and timing data from sub-

master 2 and places it in submaster 9.

[Sub] [2] [Copy To] [Sub 9] {Attrs Only} [Enter][Enter] - copies all of the submaster properties

from submaster 2 and places it in submaster 9. Levels, effects, and labels are not copied when

using the {Attrs Only} softkey.

[Sub] [2] [Copy To] [Sub 9] {Labels Only} [Enter][Enter] - copies only the label from submaster 2

and places it in submaster 9.

Releasing Content From a Submaster

To release content from a submaster, use one of the following methods:

Note: On Element 2, you will need to use the {Fader Control} softkey, which displays when

[Live] is pressed.

[Off] & [Load]- stops any running effects and fades out according to the {Restore} mode of the

submaster.

[Release] & [Load] - behaves in the same way as [Off]. [Release] no longer unmaps the fader.

[Shift] & [Load] - behaves like [Off] and [Release] except that it will also unmap the fader.

{Fader Control} {Off} & [Load]- stops any running effects and fades out according to the

{Restore} mode of the submaster.

{Fader Control} {Release} & [Load] - behaves in the same way as {Off}. {Release} no longer

unmaps the fader.

[Shift] & [Load] - behaves like {Off} and {Release} except that it will also unmap the fader.

Note: When a submaster on a motorized fader is released or turned off, the fader will

home.

Updating a Submaster

It is possible to make changes to a submaster in Live mode. [Update] is used to store changes to a

submaster.

[Update] [Sub] [5] [Enter] - updates submaster 5 to include changes in live output only for

channels already in submaster 5. You can also press the bump button for submaster 5 to

select it.

[Channel list] [Update] [Sub] [5] [Enter] - adds only the specified channels to submaster 5.

Deleting a Submaster

You can delete a submaster using the [Delete] key. When a submaster is deleted, the fader remains

configured as a submaster, but it will be empty, unless the {Unmap Faders} softkey is used.

ETC Element 2 Operating Manual

Other manuals for ETC Element 2