To Next Page

To Previous Page

196 Eos Family Operations Manual

For Example:

Assume that channels 1 through 10 are selected and set to an intensity level of 60. Select

channel 1 and dim the remaining channels.

[1] [Rem Dim] [/] [5][0] [Enter]

Channels 2 through 10 will be dimmed to 30.

Highlight and Lowlight

Eos can be placed in Highlight mode. Channels selected while in this mode will either go to a default

setting, or to a value provided by a highlight preset (established in setup, Manual Control (on

page161)). Modifications can then be made to those channels. Any changes will be maintained

when the highlight mode is removed.

To place Eos in highlight mode, press [High_Low] [Enter]. To place Eos Ti, Gio, Gio @ 5, Ion Xe, and

Element 2 in highlight mode, press [High] [Enter]. The command line will show that highlight is cur-

rently in use.

If no highlight preset is established, or for channels that have no value stored in the highlight preset,

the following values will be applied to channels as they are selected:

Intensity - full

Focus parameters - no change from present state

Color parameters - home value

Shutter parameters - no change from present state

Image parameters - home value

Form parameters - no change from present state

For Example:

1. [Group] [1] [High] [Enter] - places channels 1 through 5 in highlight.

2. [Next] - specifies channel 1.

1 is in the highlight value.

2 - 5 are in the lowlight value.

All other channels go to the defined rem dim level.

You may assign both a highlight and a lowlight preset in setup (see Manual Control(on page161)).

Any preset may be used. Channels/ parameters that are not included in the presets assigned to High-

light and Lowlight will continue to use their default highlight values (see above).

On a command line with a channel selection, you can use [Shift] & [High] to go into Highlight mode

and send the selected channels to the default Highlight setting. This command will self terminate the

command line.

If you just use [High] , the command line will be cleared.

ETC Element 2 Operating Manual

Other manuals for ETC Element 2