328 Eos Family Operations Manual
You have written cue 1, which is a multipart cue and is active. Part 2 includes channels 1
through 5 referencing intensity palette 2 which is set at 25%. Select channels 1 through 5
and change the intensity value to 21%. The data in Live will indicate the new levels in red,
and an “R” is displayed to indicate the reference has been broken.
To update cue 1 part 2, including the new intensity levels, breaking the reference to the
intensity palette, press:
[1] [Thru] [5] {Make Absolute} [Enter]
[Update] <Cue> <1> [Part] [2] [Enter]
To update cue 1 part 2 and the referenced palette with the new levels:
[1] [Thru] [5] {Intensity} [Update] <Cue> <1> [Part] [2] [Enter]
For Example:
When cue 2 is active, select channels 1 through 5 and set new levels for the color scrollers.
Update only part 4 of the multipart cue 2 with the new scroller levels.
[1] [Thru] [5] [Scroller] [Update] [Part] [4] [Enter]
Storing a Multipart Cue in Blind
CAUTION: Edits in Blind take effect immediately, they do not require a [Record] or [Update]
command.
Changing a Single Part Cue to a Multipart Cue
When working in Blind, often you will be breaking a single part cue into a multipart cue.
It is quite possible to create a new cue in Blind and follow the exact same process, except in addition
to pulling channel parameters into parts, you will also be providing them with move instructions or
block commands. It is worth noting that tracked instructions do not belong to any specific part of a
multipart cue.
Select the cue you wish to break apart and specify the first part you wish to create. Part 1 is generally
where the body of the cue resides. Therefore, if you specify any part other than part 1, all of the
move instructions in the cue are placed in part 1.
Begin by selecting any channels that you wish to move into some part other than part 1.
[1] [Thru] [5] [Part] [2] [Enter]
[6] [Thru] [1] [0] {Intensity} [Part] [3] [Enter]
[6] [Thru] [1] [0] {Color} [Part] [4] [Enter]
As you create each part, that part is now selected. It is possible to select the channel parameter you
want and press [Part] [Enter] to pull that data into the selected part.
To Next Page
Loading...
Need help?
General
