454 Eos Family Operations Manual
Element 2 is limited to one cue list.
Partitions on Cue Lists
A partition may be assigned to a cue list. If a partition has already been applied to a cue list, any chan-
nels not in the cue list's partition will not be included in cues when they stored or replayed.
Any data for a cue list that already existed before a partition is applied, will be maintained, including
data for channels not included in the partition. If data existed before the partition was assigned, in
blind, channels that are not in the partition will display without a channel graphic, any levels will be in
gray, and a small superscript N will display with it.
Assigned partitions will display at the top of the cue list index and in the PSD.
To assign a partition to a cue list:
[Cue] [n] [/] {Partition} [n] [Enter]
To remove a partition from a cue list:
[Cue] [n] [/] {Partition} [Enter]
Flexichannel in Partitioned Control
When partitioning is enabled, a flexi mode, “Partitioned” is available as a softkey. When this is
enabled, the flexi mode is limited to only those channels defined in the current partition. This mode
may be further modified by use of the remaining flexi states. See Using Flexichannel(on page66) and
FlexichannelViews in Patch (on page116) for more information.
To Next Page
Loading...
Need help?
General
