Cue Playback 311
In the above screenshot, Fader 1 has discrete disabled. There is a link icon that displays to indicate
that discrete is off. Fader 4 is set to an intensity master and is displaying an IMto indicate that.
Playback Controls
It is important to familiarize yourself with the playback controls and their locations on your console.
Please see the appropriate console geography topic for more information:
Eos Ti Geography (on page20)
Eos Geography (on page21)
Gio Geography (on page23)
Gio@5 Geography (on page24)
Ion Xe Geography(on page25)
Element 2 Geography(on page27)
Selected Cue
When in Live or Blind, if you press [Live] or [Blind] respectively, the selected cue will be the last
executed cue. This cue will appear on the command line.
When working in Live, the selected cue is always the last cue you recorded, edited, updated or
played back. When entering Blind for cues, the selected cue will be selected and displayed. Changing
the selected cue in Blind will cause the playback status display to change as well, unless preserve
blind cuehas been enabled in Setup, which will not synchronize the Blind display to the currently
selected cue but rather shows the last cue selected in Blind. When you return to Live, the selected
cue is synchronized to the currently active cue.
The attributes of the selected cue (such as timing, attributes, label and external links) are shown at
the bottom of the Live / Blind display.
On Element 2, the display is slightly different.
In Live
To load a new cue to a fader, place the cue on the command line and press [Load] for the desired play-
back. When the [Go] button is pressed, the activated cue is the selected cue.
For Example:
To Next Page
Loading...
Need help?
General
