To Next Page

To Previous Page

Working with a Single Cue List 257

For Example:

You want the time for cue 1 to be 10 minutes and 15 seconds.

[Cue] [1] [Time] [1][0][1][5] [Enter]

The command line will show the time as:

If you want the time for cue 1 to be in seconds and tenths of a second, like 1.3 seconds, you

will type using a decimal.

[Cue] [1] [Time] [1][.][3] [Enter]

The command line will show the time as:

Setting Cue Level Timing

Unless you specify otherwise, Eos assigns default fade times to any cue you record. Default timing is

designated in Setup (Cue Settings (on page153)). Cue level timing can be applied when a cue is recor-

ded or can be added or modified later.

Following are some examples of record commands with cue level timing:

[Record] <Cue> [5] [Time] [9] [Enter] - puts a time of 9 seconds on all parameter timing cat-

egories.

[Record] <Cue> [6] [Time] [3] [Time] [9] [Enter] -specifies the intensity up, focus, color, and

beam times at 3 seconds and the down time at 9 seconds. The first instance of [Time] is used

for intensity up fade (meaning intensity value is fading to a higher level than previously set)

and the second instance of [Time] is used for intensity down fade time (intensity values fading

to a lower level than previously set).

[Record] <Cue> [2] [Time] [Enter] - resets time to default value and unsplits the time, making it

the same as the up fade.

Note: Unless FCB timing is specifically set, it always defaults to the up fade time value.

Manual Timing at a Cue Level

It is possible to assign a time of manual, for manual parameter transition through the associated

fader. See ManualTiming Control (on page321) for more information. Manual times are assigned by

using the {Manual} softkey that displays after [Time] is pressed when recording a cue.

[Record] <Cue> [4] [Time] {Manual} [Enter] - applies a manual time. If the cue had previously

been given split times, would apply a manual to the up fade, focus, color, and beam times. If

the cue had a single time, all of the timing would be manual and controlled by the fader.

[Record] <Cue> [4] [Time] [Time] {Manual} [Enter] - applies a manual intensity time to the

down fade.

ETC Element 2 Operating Manual

Other manuals for ETC Element 2