Advanced Manual Control 299
[1][2] [Copy To] [2] [Sneak] <Time> 7 [Enter]
Copies the recorded data from channel 12 to channel 2 and sneaks it in 7 seconds.
Using the {HTP} softkey with [CopyTo] will cause any intensity levels to be ignored if they are less
than or equal to the copied value.
For Example:
Channels 1 and 2 are at 50% in cue 10, and in cue 11 channel 1 is at 10% and channel 2 is
at full. If you are in cue 11, and use the syntax:
[1] [Thru] [2] [CopyTo] [Cue] [1][0] {HTP} [Enter]
Channel 1 will remain at 50% and channel 2 will go to full.
Using Move To
While technically not a manual control instruction, Move To will be very useful when managing
record target data stored from manual control.
When a MoveTo command is given, data is removed from its current location and moved to its new
location. If the new location already contains data, a confirmation is required by Eos (unless disabled
in Setup). See Record Defaults (on page159) Existing data in the new location will be completely over-
written if a MoveTo command is confirmed.
Press [Copy To] [Copy To] to access MoveTo.
The following are examples of using Move To:
[Color Palette] [1] Move To <Color Palette> [5] [Enter]
[Preset] [3] Move To <Preset> [8][Enter]
[Cue] [9] MoveTo <Cue> [2] [Enter]
[Snapshot] [4] Move To <Snapshot> [7] [Enter]
[Preset] [1] Move To [Color Palette] [3] [Enter]
[Int Palette] [5] Move To [Preset] [1] [0] [Enter]
When using Move To to convert a preset into a palette, all information not relevant for that palette
will be removed.
Copy To and Move To for Labels, Scenes, and Notes
The [Copy To] and Move To ([Copy To][CopyTo]) commands can be used to copy or move labels
between any target types that can have labels. A {Labels Only} softkey will display.
[Sub] [1] [Copy To] [Sub] [3] {Labels Only} will copy submaster 1's label to submaster 2.
Labels, scenes, and notes can be copied or moved between cues. The {Labels Only}, {SceneOnly},
and {Notes Only} softkeys will display.
[Cue] [3] MoveTo [Cue] [6] {Notes Only} will move the note from cue 3 to cue 6.
To Next Page
Loading...
Need help?
General
