366 Eos Family Operations Manual
If a fader has been configured for default mapping in the fader configuration display, the fader will
receive its configuration from the Submaster List. Changes made to a submaster in the submaster
list will be shared with any default mapping faders loaded with that submaster. If changes are made
to a fader set to default mapping in the fader configuration display, those changes will also happen
in the Submaster List. If set to Local, any changes made in the fader configuration display will impact
only that instance of the content.
The following options are available when a fader is configured as a submaster:
Mode
You may define your submaster as additive (contributes to the live output), inhibitive (limits live out-
put) or an effect submaster. Eos defaults to submasters being additive.
Additive submasters are indicated by a green LED and a yellow fader icon in the fader ribbon.
Inhibitive submasters display these indicators in red. Channels mastered by an inhibitive submaster
are indicated with an “I” next to the intensity value in the channel display in live. Inhibitive sub-
masters do not provide levels to the stage picture, they limit them (similar to a grandmaster). It is pos-
sible to put non-intensity parameters onto an inhibitive submaster, but it must be done from blind.
For more information about effect submasters, see Effects on Faders (on page352).
Master
A fader can be assigned as a Master. When it is a master, its behavior as a Proportional Master or
Intensity Master (I-Master) is drawn from this setting.
Proportional Master
When a submaster is proportional, the slider will control all contents of the submaster (intensity and
non-intensity parameters) when moved from zero. When a proportional sub is returned toward
zero, channel will be returned to their previous level.
The bump button can be used to bump all values to their recorded levels in the submaster, or, by
assigning timing values, fade the contents of the submaster up or out. Eos defaults to submasters as
proportional.
Intensity master
When set to intensity master, the slider will control intensity only. The bump button can be used to
preset (mark) non-intensity parameters stored to the submaster. If the bump is not pressed before
the slider is moved, the slider will also fade the non-intensity-parameters to their recorded values.
To Next Page
Loading...
Need help?
General
