504 Eos Family Operations Manual
Analog inputs and network inputs use the external setting only as a way to enable and disable the
entire list.
Creating an Event List
Getting started with an event list is the same regardless of which show control protocol you are
using.
To program an event list, you first must open the show control display.
[Displays]><More SK>>{Show Control}
Create an event list by specifying it in the command line.
<Event> [1] [/] [Enter]
Specify what the list will respond to (MIDI, SMPTE, Analog, or RTC).
<Event> [1] [/] {Type} {MIDI} [Enter]
Define the group or source.
<Event> [1] [/] {Source} [8] [Enter]
Activate the internal and/or external timing functions (see Internal vs. External Time (on theprevious
page)). These functions are toggle on/off states.
<Event> [1] [/] {Internal} {External} [Enter]
When defining an event list, it is feasible to enter multiple commands in the same command line. This
can speed up your programming of an event list. For example:
<Event> [2] [/] {Type} {MIDI} {Source} [5][Enter]
Once the list is created, you will then need to create the specific events. Those steps will vary depend-
ing on what protocol is being used.
To Next Page
Loading...
Need help?
General
