To Next Page

To Previous Page

508 Eos Family Operations Manual

Event timing can also be modified within a range. Let's say an additional 5 frames needs to be added

to multiple events.

<Event> [1] [Thru] [4] [Time] [+] [5] [Enter]

Note: You will notice as events are added to the event list, the time code will display on the

Playback Status Display.

Adding Events From Live

Events can be added directly from live using the same conventions used in the Show Control Display.

The advantage to doing this from Live is there is no need to specify the event number, as the console

automatically assigns the number.

From the Live Display Select the cue to execute.

[Cue] [3]

Now define the time code location.

[Cue] [3] {Execute} {Timecode} [3][2][1][5] [Enter]

Note: You will notice as events are added to the event list, the time code will display on the

Playback Status Display.

Adding Events using Learn Mode

If you select an event list within the show control display, you can press the [Learn] hardkey to activ-

ate learn mode for that event list. When in learn mode, an event is created with the current list time

whenever a cue is activated, a submaster bump is pressed, or a macro is run. Once in learn mode, the

[Learn] key will remain lit to indicate that it is in learn mode. If the show control display is exited, the

console remains in learn mode until deactivated.

Multiple time code lists can be in learn mode simultaneously, each with their individual times. It is

recommended that you associate the event list and cue list together, so events will be learned into

the intended time code list.

To exit learn mode, the console must be in the show control display. Once there, select the event list

then press [Learn] again. If [Learn] is pressed while viewing any other screen than the show control

display an empty event will be placed on all event lists that are in learn mode.

Open the show control display.

[Displays]<More SK>{ShowControl}

Select the event list to enable learning on.

<Event> [1] [/]

Press the [Learn] key.

<Event> [1] [/] [Learn]

In the Status column it now says Learning, and the [Learn] button is illuminated.

ETC Element 2 Operating Manual

Other manuals for ETC Element 2