Programming manual.
CNC 8070
TECHNOLOGICAL FUNCTIONS
6.
Auxiliary (miscellaneous) functions (M)
·117·
(REF: 1709)
6.6.1 List of "M" functions
Program Interruption (M00/M01)
M00
Program stop.
Function M00 interrupts the execution of the program. It does not stop the spindle or initialize
the cutting conditions.
The [CYCLE START] key of the operator panel must be pressed again in order to resume
program execution.
This function should be set in the "M" function table so it is executed at the end of the block
where it is programmed.
M01
Conditional program stop.
When the external conditional stop switch is active (PLC signal "M01 STOP"), it interrupts
program execution. It does not stop the spindle or initialize the cutting conditions.
The [CYCLE START] key of the operator panel must be pressed again in order to resume
program execution.
This function should be set in the "M" function table so it is executed at the end of the block
where it is programmed.
Tool change (M06)
M06
Tool change.
The M06 function executes the tool change. The CNC will manage the tool change and
update the table for the tool magazine.
This function should be set in the "M" table so it executes the subroutine corresponding to
the tool changer installed on the machine.
To Next Page
Loading...
