CNC 8070
1
·31·
(REF: 1709)
CREATING A PROGRAM.
1.1 Programming languages.
The CNC has its own programming language described in this manual. The program is edited
block by block and each one may be written in ISO language or in High level language. See
"1.3 Program block structure." on page 35.
When editing high level commands, the editor offers a list of available commands.
8055 language.
Programs can also be edited in the 8055 CNC language. Programming in 8055 CNC
language is enabled from the part-program editor. Refer to the operating manual to enable
this option.
This manual does not describe the 8055 language; refer to the specific documentation for
this product. Obviously, since this CNC and the 8055 are two functionally different products,
some concepts may be different.
To Next Page
Loading...
