Fagor 8070 BL - 9.2 Exclusive Manual Intervention (G200)

Programming manual.
CNC 8070
TOOL PATH CONTROL. MANUAL INTERVENTION.
9.
Exclusive manual intervention (G200).
·171·
(REF: 1709)
9.2 Exclusive manual intervention (G200).
With exclusive manual intervention, the axes may be jogged using handwheels or jog keys
(continuous or incremental) by interrupting the execution of the program. This function can
be applied on any axis of the machine; however, it cannot be applied on the spindle, although
this can work in positioning mode.
To cancel manual intervention and resume program execution, press the [CYCLE START]
key.
Programming.
To activate the additive manual intervention, the function G200 must be programmed in the
same block, followed by the #AXIS statement with the applicable axes. Programming G200
alone applies the manual intervention on all the axes.
Programming format.
The programming format is the following; the arguments appear between curly brackets and
the optional ones between angle brackets.
G200
G200 #AXIS[{axis}, .. , {axis}]
Considerations
If a manual intervention is executed before a circular interpolation and one of the axes
involved in the circular interpolation is jogged, it could issue an error message indicating that
a circle has been programmed wrong or it may execute a circle other than the one
programmed.
Properties of the function and Influence of the reset, turning the
CNC off and of the M30 function.
Function G200 is non-modal and is incompatible with functions G201 and G202. On power-
up, after executing an M02 or M30, and after an emergency or reset, the CNC assumes
function G202.
{axis} Axis name.
Units: -.
G200 #AXIS [X, Z]
(Interrupt the execution and activate additive manual intervention on XZ
axes)
G200
(Interrupt the execution and activate additive manual intervention on all
axes)