Fagor 8070 BL - Sections of Tool Radius Compensation

Programming manual.
CNC 8070
TOOL COMPENSATION
13.
Tool radius compensation
·251·
(REF: 1709)
13.1.4 Sections of tool radius compensation
The way the compensated paths are joined depends on the type of transition selected
(G136/G137).
The following tables show the different transition possibilities between various paths
depending on the selected function G136 or G137. The programmed path is shown with solid
line and the compensated path with dashed line.
STRAIGHT-TO-STRAIGHT PATH
When the angle between paths is smaller than or equal to 180º, the transition between paths
is independent from the G136/G137 function selected.
When the angle between paths is greater than 180º, the way the compensated paths are
joined depends on the type of transition selected (G136/G137).
0º <  < 90º  = 90º
90º <
 < 180º
G136 G137
180º <
 < 270º 180º <  < 270º
 = 270º  = 270º
270º <
 < 360º 270º <  < 360º