Fagor 8070 BL - G192. Turning Speed Limitation

Programming manual.
CNC 8070
7.
THE SPINDLE. BASIC CONTROL.
Spindle speed
·124·
(REF: 1709)
7.2.1 G192. Turning speed limitation
Function G192 limits the spindle turning speed in both work modes; G96 and G97. This
function is especially useful when working at constant cutting speed while machining large
parts or when doing spindle maintenance work.
If function G192 is not programmed, the turning speed is limited by machine parameter
G00FEED of the gear.
G192. Programming the turning speed limit
The turning speed limit is set by programming function G192 and then the maximum speed
for each spindle. This function may be programmed while the spindle is running; in this case,
the CNC will limit the speed to the new programmed value.
Programming format
The spindle may have any name in the S, S1...S9 range. There is no need to program the
"=" sign for the "S" spindle.
G192 Sn={vel}
G192 S{vel}
The maximum turning speed is always set in RPM. It is possible to program using arithmetic
parameters, variables or expressions.
Properties of the function and Influence of the reset, turning the
CNC off and of the M30 function.
Function G192 is modal.
The CNC cancels function G192 on power-up. After executing an M02 or M30, and after an
emergency or a reset, the CNC maintains function G192.
{vel}
Maximum spindle speed.
G192 S1000
G192 S1=500