Fagor 8070 BL - Canceling the Execution Resuming Point

Programming manual.
CNC 8070
15.
EXECUTING BLOCKS AND PROGRAMS
Abort the execution of the program and resume it in another block or
program.
·296·
(REF: 1709)
Considerations.
It is recommended to program the target labels at the beginning of the program, outside the
main program. Otherwise, and depending on the length of the program, if the jump labels
are defined at the end of it, the #ABORT instruction may take longer to find them.
15.3.2 Canceling the execution resuming point.
The point where the execution is resumed is canceled with the #ABORT instruction. If no
resume point has been defined or it has been canceled, the execution continues in the
#ABORT OFF instruction; if the instruction has not been defined, the program will jump to
the end of the program (M30).
Programming.
Program the instruction alone in the block.
Programming format.
The programming format is:
#ABORT OFF
#ABORT OFF