Programming manual.
CNC 8070
THE SPINDLE. BASIC CONTROL.
7.
The master spindle of the channel
·121·
(REF: 1709)
• If two or more spindles remain in a channel and none of the previous rules can be applied,
it applies the following criteria.
If any of the spindles is the original master, it is assumed as master spindle. If it is parked,
it selects the next spindle from the original configuration (those defined by the machine
parameters) and so on.
If no spindles from the original configuration are available in the channel, it assumes as
master spindle the first one of its current configuration. If it is parked, it selects the next
spindle and so on.
Which one is the master spindle after parking or unparking
spindles?
The same treatment is applied as when modifying the configuration of the channel.
To Next Page
Loading...
